ZyXEL Communications Prestige 782R, User Manual, Page: 139 / 166

Prestige 782R G.SHDSL Router
IP Routing Policy Setup 11-5
FIELD DESCRIPTION
addr start / end Source IP address range from start to end.
port start / end Source port number range from start to end; applicable only for TCP/UDP.
Destination:
addr start / end Destination IP address range from start to end.
port start / end Destination port number range from start to end; applicable only for TCP/UDP.
Action
Specifies whether action should be taken on criteria Matched or Not
Matched .
Gateway addr Defines the outgoing gateway address. The gateway must be on the same
subnet as the Prestige if it is on the LAN, otherwise, the gateway must be the
IP address of a remote node. The default gateway is specified as 0.0.0.0.
Type of Service Set the new TOS value of the outgoing packet. Choose from prioritize
incoming network traffic by choosing from
No Change / Normal / Min Delay /
Max Thruput / Max Reliability / Min Cost .
Precedence Set the new outgoing packet precedence value. Values are 0 to 7 or No
Change .
Log Press [SPACE BAR] to select Yes to make an entry in the system log when a
policy is executed.
11.5 Applying an IP Policy
This section shows you where to apply the IP policies after you design them.
11.5.1 Ethernet IP Policies
From Menu 3 – Ethernet Setup , type 2 to go to Menu 3.2 – TCP/IP and DHCP Ethernet Setup .
You can choose up to four IP policy sets (from 12) by typing their numbers separated by commas, e.g., 2, 4,
7, 9.