ZyXEL Communications Prestige 782R, User Manual, Page: 131 / 166

Prestige 782R G.SHDSL Router
System Maintenance 10-17
The following table describes some of the fields that you may see in third-party TFTP clients.
COMMAND DESCRIPTION
Host Type your IP address. 192.168.1.1 is the Prestige default IP address when shipped.
Send/Fetch Press [Send] to upload the file to the Prestige and [Fetch] to back up the file on your
computer.
Local File Type the path and firmware file name (*.bin extension) or configuration file (*.rom
extension) on your computer.
Remote File The Prestige filename. The firmware filename is ras
.
The configuration file, is rom-0 .
Binary Transfer the file in binary mode.
Abort Stop transfer of the file.
10.7.4 Boot Module Commands
When you reboot your Prestige, you will be given a choice to go into debug mode by pressing a key at the
prompt shown in the following screen. In debug mode you have access to a series of boot module
commands, for example
ATUR (for uploading firmware) and ATLC (for uploading the configuration file)
already discussed in a previous section.
Figure 10-19 Option to Enter Debug Mode
Type ATHE to view all available Prestige boot module commands. Some are shown in the next screen.
Most commands aid in advanced troubleshooting and should only be used by qualified engineers.
Bootbase Version: V2.00 | 4/14/2001 13:58:03
RAM: Size = 8192 Kbytes
FLASH: Intel 8M *2
ZyNOS Version: V2.50(BH.0)b5 | 12/12/2001 14:01:55
Press any key to enter debug mode within 3 seconds.
.................................................