Chapter 10 NAT
LTE5366 Series User’s Guide
98
10.4 Port Trigger Screen
To change your LTE5366’s trigger port settings, click
Configuration > Network > NAT > Port Trigger
. The
screen appears as shown.
Note: Only one LAN computer can use a trigger port (range) at a time.
Figure 61
Configuration > Network > NAT > Port Trigger
The following table describes the labels in this screen.
Table 40 Configuration > Network > NAT > Port Trigger
LABEL
DESCRIPTION
#
This is the rule index number (read-only).
Name
Type a unique name (up to 15 characters) for identification purposes. All characters are
permitted - including spaces.
WAN Interface
Select the WAN interface through which the matched packets are transmitted.
Incoming Port
Incoming Port is a port (or a range of ports) that a server on the WAN uses when it sends out a
particular service. The LTE5366 forwards the traffic with this port (or range of ports) to the client
computer on the LAN that requested the service.
Start Port
Type a port number or the starting port number in a range of port numbers.
End Port
Type a port number or the ending port number in a range of port numbers.
Trigger Port
The trigger port is a port that causes (or triggers) the LTE5366 to record the IP address of the
LAN computer that sent the traffic to a server on the WAN.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Apply
Click
Apply
to save your changes back to the LTE5366.
