Chapter 4 Tutorials
LTE5366 Series User’s Guide
37
4.3 Connect to LTE5366 Wireless Network without WPS
This example shows you how to configure wireless security settings with the following parameters on your
LTE5366 and connect your computer to the LTE5366 wireless network.
Follow the steps below to configure the wireless settings on your LTE5366.
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see
).
1
Make sure the
WIFI
switch (at the back panel of the LTE5366) is set to
ON
.
2
Open the
Configuration >
Network
>
Wireless LAN > General
screen in the AP’s Web Configurator.
3
Confirm that the wireless LAN is enabled on the LTE5366.
4
Enter
SSID_Example3
as the SSID and select
Channel-06
as the channel. Set security mode to
WPA2-PSK
and enter
1234567890
in the
Pre-Shared Key
field. Click
Apply
.
5
Open the
Status
screen. Verify your wireless and wireless security settings under
Device Information
and
check if the WLAN connection is up under
Interface Status
.
SSID
SSID_Example3
Channel
6
Security
WPA-PSK
(Pre-Shared Key: 1234567890)
