ZyXEL Communications IES-1248-51A, User Manual

Page: 149 / 654

Chapter 17 xDSL Profiles Setup
IES-1248-51V User’s Guide
149
The following table describes the labels in this screen.
Table 28 Alarm Profile
LABEL DESCRIPTION
xDSL Profile Click xDSL Profile to open the Port Profile screen (see Section 17.1
on page 139 ). Use the Port Profile screen to configure profiles of
ADSL port settings (such as the transfer rate, interleave delay and
signal to noise ratio settings).
VC Profile Click VC Profile to open the VC Profile screen where you can
configure virtual channel profiles (see
Section 17.5 on page 146 ).
Name This field is read-only if you click Modify to edit a port profile. Type a
name to identify the alarm profile (you cannot change the name of
the DEFVAL profile). You can use up to 31 ASCII characters; spaces
are not allowed.
Add Click Add to save your changes to the IES-1248-51V’s volatile
memory. The IES-1248-51V loses these changes if it is turned off or
loses power, so use the Config Save link on the navigation panel to
save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to start configuring the screen again.
Threshold Specify limits for the individual performance counters. The IES-1248-
51V sends an alarm trap and generates a syslog entry when one of
these thresholds is exceeded. A value of 0 disables the alarm
threshold.
ATU-C These fields are for traffic coming from the subscriber’s device to the
IES-1248-51V.
ATU-R These fields are for traffic going from the IES-1248-51V to the
subscriber’s device.
15 Min LOF This field sets the limit for the number of Loss Of Frame seconds that
are permitted to occur within 15 minutes.
15 Min LOS This field sets the limit for the number of Loss Of Signal seconds that
are permitted to occur within 15 minutes.
15 Min LOL This field sets limit for the number of Loss Of Link seconds that are
permitted to occur within 15 minutes.
15 Min LPR This field sets the limit for the number of Loss of Power (on the ATUR)
seconds that are permitted to occur within 15 minutes.
15 Min ES
(seconds) This field sets the limit for the number of Errored Seconds that are
permitted to occur within 15 minutes.
15 Min SES
(seconds) This field sets the limit for the number of Severely Errored seconds
that are permitted to occur within 15 minutes.
15 Min UAS
(seconds) This field sets the limit for the number of UnAvailable seconds that
are permitted to occur within 15 minutes.
15 Min Failed Fast
Retrain This field sets the limit for the number of failed fast retrains that are
permitted within 15 minutes.
Init Failure Trap Select Active to trigger an alarm for an initialization failure trap.
Fast Rate Up
(bps) Specify a rate in kilobits per second (kbps). If a fast mode
connection’s upstream transmission rate increases by more than this
number, then a trap is sent.