ZyXEL Communications G-570U, User Manual

Page: 68 / 162

ZyXEL G-570U User’s Guide
68 Chapter 6 Wireless Screens
6.3.4 AP+Repeater Mode
Select AP+Repeater as the Operation Mode to have the device act as an access point and a
wireless bridge.
Wireless Mode Select 802.11a only to allow only IEEE 802.11a compliant WLAN devices to
associate with the device.
Select
802.11b only to allow only IEEE 802.11b compliant WLAN devices to
associate with the device.
Select
802.11g only to allow only IEEE 802.11g compliant WLAN devices to
associate with the device.
Select
Auto (11g/11b) to allow either IEEE 802.11b or IEEE 802.11g compliant
WLAN devices to associate with the device. The transmission rate of your device
might be reduced.
Local MAC
Address
This is the MAC address of the device.
Remote MAC
Address 1~4
Type the MAC address of the peer device in a valid MAC address format; six
hexadecimal character pairs (for example, 12:34:56:78:9a:bc).
Advanced Settings
Radio Enable Turn on the wireless adapter to allow wireless communications between the device
and other wireless devices. Turn off the wireless adapter to stop wireless
communications between the device and other wireless devices.
Data Rate
Management
Use this field to select a maximum data rate for the wireless connection(s). Please
note that this is a total rate to be shared by all of the device’s wireless connections.
Preamble Type Preamble is used to signal that data is coming to the receiver.
Short preamble increases performance as less time sending preamble means
more time for sending data. All IEEE 802.11b compliant wireless adapters support
long preamble, but not all support short preamble.
Select
Long preamble if you are unsure what preamble mode the wireless
adapters support, and to provide more reliable communications in busy wireless
networks.
Select
Dynamic to have the device automatically use short preamble when all
wireless clients support it, otherwise the device uses long preamble.
Note: The device and the wireless stations MUST use the same
preamble mode in order to communicate.
RTS/CTS
Threshold
Enter a value between 0 and 2346. The default is 2346 .
Fragmentation Enter a value between 256 and 2346. The default is 2346 . It is the maximum data
fragment size that can be sent.
Apply Click Apply to save your changes back to the device.
Reset Click Reset to begin configuring this screen afresh.
Table 13 Wireless Settings: Bridge (continued)
LABEL DESCRIPTION