FV801 Rev. A 06/21/21
Page 5
1. Install Monitor on wall surface within 2 feet radius of faucet
with dry wall anchors & screws or doubled sided VHB tape
2. Loosen lid screw with supplied 3mm Allen wrench. Open lid
and install supplied batteries. Close lid and tighten lid screw.
4. Connect sensor inline connector to electronics module
and hydrogenerator.
Do not connect cable to the monitor at this step.
Use AA Lithium Batteries or AA Alkaline batteries, but do not mix Lithium
with Alkaline.
Monitor & Electronic Module Installation Instructions
3.
Connect the hydrogenerator(A) downstream of electronics
module(B) and filter(C) to bottom of electronics module.
B
A
C
