FV801 Rev. A 06/21/21
Page 2
Overview:
Zurn connected faucets transmit data 24/7 to the Zurn plumbSMART™* web portal and mobile app. Proactively
monitor your faucet activations and water usage, receive real-time alerts for preset high and low usage parameters,
and access system data for trends and predictive maintenance anytime and anywhere.
AquaSense® sensor faucets are ideal for high-use applications where durability and hands-free operation are
necessary. ADA compliant, battery powered, polished chrome-plated cast brass sensor faucet with infrared proximity
sensor for retrofit and new construction. Unit is furnished with a standard 0.5 GPM aerator, and mounting hardware.
Zurn Lead Free products (-XL) are designed and manufactured to comply with Section 1417 of the Safe Drinking
Water Act (SDWA) which mandates the weighted average lead content of no more than 0.25% of the wetted surface
NOTE: The information in this manual is subject to change at any time without notice. Installations may be performed
at different times of construction by different individuals. For this reason, these instructions should be left on-site
with the facility or maintenance manager.
Specifications:
Voltage:
6 VDC Series [4 “AA” (Alkaline or Lithium)] for faucet
4 VDC Series [4 “AA” (Alkaline or Lithium)] for monitor
Sensor Range:
Self-calibrated, dependent upon sink depth and finish.
Operating Water Pressure:
10-125 psi
Operational Water Temperature:
33°F to 140°F (1°C to 60°C)
Aerator:
0.5 GPM Vandal-Resistant (Standard)
Important Safety Information:
• Installer is responsible for ensuring the product is installed and conforms to all plumbing codes and ordinances.
•
Do not convert or modify this Zurn product yourself. All warranties will be voided.
• Water supply lines must be sized according to building designer in order to provide adequate water supply
for each fixture.
•
Flush all water lines prior to making connections.
Be sure the water supply is turned on and the sink/lavatory/basin is clear from any objects upon making the sensor to electronics
connection initiating the self-calibration feature. The sink must be clear of any and all objects and water supply is turned on in order
to calibrate appropriately (calibration time approx 30-60sec) (the system will perform both a wet & dry calibration).
Prior to Installation:
Before installing your Zurn
®
Aqua-FIT
®
Faucet: the items listed below should already be installed on site.
•
Lavatory/sink
•
Drain Line
• Hot and cold water supply line or pre-tempered water supply line.
•
Installer/Servicer should not use pipe dope or teflon/thread sealant anywhere on this product, most notably threads
and connection points.
•
Care shall be taken when installing this product to prevent marring of any exposed or decorative surfaces.
Warning: Do note connect an external power supply to the hydrogenerator’s barrel jack connector. Doing so could reduce product
performance or pose a fire hazard.
