Layer 2
QoS
This contains the value used for layer 2 802.1Q/VLAN tag and
802.1p priority value. Default setting is 0.
Local RTP
port
This parameter defines the local RTP port pair used to listen
and transmit. It is the base RTP port for channel 0. When
configured, channel 0 will use this port _value for RTP; channel
1 will use por2 for RTP. Local RTP port ranges from
1024 to 65400 and must be even. The default value is 5004.
Use
Random
Port
This parameter, when set to “Yes”, will force random generation
of both the local SIP and RTP ports. This is usually necessary
when multiple ZXV10 P802Ls are behind the same NAT.
Default is “No”.
Keep-alive
interval
This parameter specifies how often the ZXV10 P802L sends a
blank UDP packet to the SIP server in order to keep the “hole”
on the NAT open. Default is 20 seconds.
Use NAT IP NAT IP address used in SIP/SDP message. Default is blank.
STUN
Server
IP address or Domain name of the STUN server. STUN
resolution result will display in the STATUS page of the Web UI.
Firmware
Upgrade
and
Provisionin
g
Allows the user to select the following options for firmware
upgrade:
Always Check for New Firmware
Check New Firmware only when F/W pre/suffix changes
Always Skip the Firmware Check.
Firmware upgrade may take up to 10 minutes depending on
network environment. Do not interrupt the firmware upgrading
process.
Note:
ZTE strongly recommends that the user upgrade
firmware locally in a LAN environment if using TFTP to
upgrade. Please DO NOT interrupt the upgrade process
(especially the power supply) as this will damage the device.
XML Config The password used for encrypting the XML configuration file
