English - 23
IB v3.0.0 2021
© 2021 ZES - All rights reserved
1-
Insert cable through the cable gland. Pull the cable through the cable clamps as indicated
by arrows in below figure.
3-
Using a Crimping Tool, trim the end of the
cable you’re terminating, to ensure that the
ends of the conducting wires are even.
4-
Strip off approximately 1 inch of the cable’s
jacket, using a modular crimping tool or a
UTP cable stripper.
5-
Separate the 4 twisted wire pairs from
each other, and then unwind each pair, so
that you end up with 8 individual wires.
6-
Moving from left to right, arrange the
wires in a flat, side-by-side ribbon formation,
placing them in the following order: white/
orange, solid orange, white/green, solid blue,
white/blue, solid green, white/brown, solid
brown.
7-
Carefully insert the flattened, arranged wi
-
res into the connector, pushing through until
the wire ends emerge from the pins.
8-
Check to make sure that the wire ends
coming out of the connector’s pin side are in
the correct order. If you realize that a mistake
has been made in wire order after termina-
tion, you’ll have to cut the connector off and
start all over again!
