Software User’s Manual Ver.A1D-502-V8.03.30-NB
97
configuration enabled, but the message in the body text will be based upon the
Notification messages.
In general, please stick to the
“
one email per event rule
”
limit for best performance.
Change Motion Detection Profile: This will switch the profile of the selected Motion
Detection region from Runtime profile to Event profile. The profile will return to
runtime settings at the end of this event. You may program one motion detection
region to be disabled at runtime, but enable it with event handler under some
circumstances.
Send URL command: Select the URL command to include in the response set. Two
different commands will be sent at the time when the event is triggered and un-
triggered. For example, going to a preset point, if the device is a PTZ camera, and
there are preset points already configured in PTZ setup page, then you may include
this in the response section of the event rule by using Send URL Command method.
It is possible to let the camera return to another preset point at the end of the event.
Change Day / Night Mode (selected models only): For some models, you may force
the Camera into Day or Night mode. The camera will return to its previous setting
(whether auto or forced day/ night) upon the end of the event.
Send Message to the Notification Server: This function works only if Notification
Server has been activated (see Notification Server Configuration on page 83).
Send Message to the NVR: This function works only if an NVR has been configured in
NVR Configuration (on page 83). When an event is triggered, a notification will be
sent to the NVR.
Play the audio file: This function plays the audio file configured in
5-6-6
Audio
(on
page 78) when the event is triggered. Define the duration of audio file playback.
After changing any of the items above, press Apply to save the changes. The Reset button
undoes the changes that had just been made but not applied yet.