Software User’s Manual Ver.A1D-502-V8.03.30-NB
96
Device boots successfully: This will trigger the event responses once the device boots
up. You can use this to create a notification system that keeps record of when the
device has been rebooted via email.
Reboot device: This triggers the event response when the device is shut down via web
UI
“
Save and Reboot
”
. Use this to keep record of when was the device setting edited.
Note that this will not take effect when the device is unplugged, as this is not normal
shutdown.
Fail to write storage (with storage card only): Trigger occurs when there is an error
in writing data to the memory card.
Remove storage media (with storage card only): Trigger occurs when the memory
card is suddenly removed from the device.
Tamper: The event is triggered when the camera is tampered with. For example, the
camera is sprayed with paint, etc.
Security Detection: The event is triggered when a security event, such as
“
Enter
Area
”
is detected. See
5-6-2-3 Security
on page 56.
Line Crossing: The event is triggered when line crossing is detected. See
5-6-2-2
Line Crossing
on page 54.
What responses will occur?
Available responses vary depending on what triggered the event.
Digital Output (selected models only): This is a useful link to other devices. Click to
include this in the response for this rule.
Send notification Message: Select from the three pre-defined messages which you
’
ve
setup in the Event Configuration section. You may enable multiple messages at the
same time. For sending Email, please limit the recipient to one per event rule. If you
need to send email to more than one recipient, please use separate event rules
triggered by the same trigger.
Upload video/snapshots: Select which of the event configurations to include in this
response set. If you are sending email via upload video and sending notification
message at the same time, the system will automatically merge the two emails into
one. The subject and image will be based upon the Upload snapshot Event