Software User’s Manual Ver.A1D-502-V8.03.30-NB
32
You can enable V1, V2 or both. Click
“
Apply
”
after you
’
ve completed setup.
The security method of SNMP V3 uses account/password for authentication.
“
Security
Name
”
is the account name to be used with your
“
Password
”
. The default security name is
“
public
”
and the password must be at least 8 characters long. You also can set any other
security name or password. Click
“
Apply
”
after you
’
ve completed setup.
SNMP function is now enabled. You may now install and run the SNMP management
software on computer server.
SNMP Trap Usage:
SNMP traps enable notifications from devices. Devices may send message to the
management server whenever significant events occur such as cold start, warm start
and authentication failure. The manager will get the information immediately and take
action if necessary.
Cold start means device reboot by power disconnection. Warm start means device
reboot by firmware without power disconnection. If there other parties attempt to
connect to the device with wrong security password under SNMP V1, V2 or V3 setting,
the device will send an authentication failure message to the management server.
To enable SNMP Trap function in the camera, type the IP address of the computer
running the SNMP management software and type trap community as password to allow
server to get trap message from device (Default is public). Select available traps and
click
“
Apply
”
.