3
、
INTAKE SYSTEM COMPONENT
20
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1251100-101000 Non-standard bolt M6×12 (304 stainless steel)
3
2
1050961-004000 Air filter intake air temperature sensor
1
4
1051371-002000
Φ59×9 pipe clamp assembly
1
5
1274200-088000
ZT310 water pipe clamp(φ10.5)
4
8
1251300-063093 Plywood M6×11×15(color Zinc)
7
9
1224300-005000 ZT350-V air filter
1
10
1050954-009000 YH canister solenoid valve
1
11
1250303-010093 GB6177.1M6 (environmental color)
1
12
1224100-012000 ZT250-S carbon tank
1
plug, which should be 35
±
2
Ω
, otherwise the solenoid valve fault can be judged.
●
Check whether the temperature sensor is damaged
Remove the temperature sensor from the air filter and place it in the ambient temperature (20
～
30
℃
), and use a multimeter to check whether the resistance of the two pins is between 2726
～
1770 Ω.
CAUTION:
●
Remove the side cover,seat cushion,fuel tank,etc. in advance.
●
Regularly check whether the filter element of the carbon tank and air filter is not ventilated,
otherwise it may cause the oil supply to affect the driving experience.
●
It should be no crimp, entanglement and other phenomena.
1
7
1244200-096000 ZT310-V canister electromagnetic valve inlet manifold
(Φ5×Φ11/Φ7×Φ13)
1
PROCEDURE:
●
Air filter assembly
Remove the air filter intake air temperature sensor
⑵
from the air filter. If the sealant falls off, it needs to be
plugged back to its original position. Remove the clamp
⑷
.
Remove the 3 bolts
⑴
from the 4# inner hexagon, respectively, and remove the air filter assembly from the
car. Need to constantly adjust the angle to take out.
Remove 7 pieces of clamp nuts
⑻
.
The oil accumulation pipe
①
and the water accumulation pipe
②
should be checked and cleaned regularly.
●
Carbon Tank Assembly
Remove the clamp attached to the adsorption pipe (3) and pull the pipe out of the carbon canister.Use
hoop pliers to remove the carbon canister and the 4 pieces of clamps
⑸
on the solenoid valve end of the
carbon canister, and then pull out the air outlet pipe
⑹
and the intake pipe
⑺
.
Remove the carbon canister
⑿
.
●
Carbon tank electromangnetic valve
Remove the nut
⑾
with the 10# sleeve; remove the solenoid valv
⑽
.
●
Check the carbon canister solenoid valve:
In case of poor engine performance; Poor idle speed; If the air-fuel ratio is incorrect, check the carbon
canister solenoid valve.
Use a multimeter to measure the resistance between the two inserts of the carbon canister solenoid valve
Fig.2 INTAKE SYSTEM
COMPONENT
Air filter components 2
6
1244200-097000
ZT310-V canister solenoid valve vent manifold (Φ4×Φ
10/Φ5×Φ11)
1
3
1246400-012000
ZT350T-D carbon canister adsorption tube (φ5×φ9×
450)
