1
、
FRAME COMPONENT
8
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1184300-025000 ZT350-S wiring harness assembly-A
1
2
1224100-030000 Pin tie (Black 4.8×130)
1
3
1224100-037000 Grade 0 flame retardant tie (black 3.6×295)
3
4
1244200-103000 ZT310 relay rubber sleeve
5
5
1244100-082000 ZT250-R dump switch sleeve
1
6
1184100-002000 ZT250-S dump switch
1
7
1180300-101000 HJ150-3 square flasher (LED)
1
8
1251100-101000 Non-standard bolt M6×12 (304 stainless steel)
5
9
1224200-205000 ZT310 electronic cushion lock block
1
10
1274100-058000 ZT310 Electric seat lock
1
11
1274300-111000 ZT350
－
S rear tail skirt bracket
1
12
1184100-017000 ZT250-S fuel-injection relay
5
KH-1A4T
13
1224300-110000 Reverse buckle Velcro strap (20×200mm)
8
14
1224300-111000 Reverse buckle Velcro strap (20×300mm)
4
15
1184300-002000 ZT350 starting relay
1
16
1251100-102000 Non-standard bolt M6×16 (304 stainless steel)
1
17
1274200-171000 ZT310-V relay bracket
1
18
1251300-085093 Non-standard cap nut M6
2
20
1274200-268000 ZT310-VX Bosch ECU bracket
1
Fig.1 FRAME&ELECTRONIC PARTS
COMPONENT
Electronic parts COMPONENT-1
19
1050958-014000 MSE6.0 controller - ZT184MP (matching split sensor /
Euro V)
1
PROCEDURE:
●
Flasher and dump switch
Remove the rubber sleeve that connects the flasher
⑺
to the mounting bracket on the frame, and remove
the dump switch with the same method, then separate the dump switch sleeve
⑸
.
●
Relay and ECU
Pull out the rubber sleeve
⑷
on the right side of the frame and upper the air filter,and then pull out the EFI
relay
⑿
. Find the starting relay
⒂
above the air filter, pull off the sheath of the harness, remove the self-
contained nut and remove the relay from the relay support
⒄
. Remove the bolt
⒃
with 4# hexagon socket
and remove the bracket
⒄
. Unplug the plug of the engine controller
⒆
on the left and remove the nut
⒅
with
a 10# sleeve. Remove 2 bolts
⑻
with 4# socket head and then remove ECU bracket
⒇
.
●
Seat lock
Take off the plug of the seat lock , and cut off binding
⑶
. Use a 4# inner hexagon to remove the front bolt
⑻
, and remove the guide block
⑼
; remove the 2 rear bolts and remove the electronic cushion lock
⑽
ankd
the rear tail skirt bracket
⑾
.
●
Main harness
Different plug-in methods are different, please unplug all the electrical components connected to the
main thread according to the actual operation. It needs to use a screwdriver, forceps, scissors and
other tools to assist.The binding
⑶
can be picked out by using scissors.Take off straps
⒀
and
⒁
.
CAUTION
：
●
Please notice the limit of the bracket when dismantling flasher and dump switch sleeve, beware of
hurting your fingers.
