ZOLL Propaq MD, Service Manual

Page: 28 / 142

C
HAPTER
1 M
AINTENANCE
T
ESTS
22 9650-0807-01 Rev. C
8.0 Shock Test
WARNING! Take the necessary precautions to guard against shock or injury before you start
conducting the defibrillator tests.
Keep hands and all other objects clear of the multi-function cable connections and
defibrillator analyzer when discharging the defibrillator.
Before you discharge the defibrillator, warn everyone near the equipment to STAND
CLEAR.
Equipment
Fluke Impulse 7000 DP Analyzer (or equivalent), stop watch
Do This... Observe This... Pass/Fail
8.1 Turn on the Analyzer.
8.2 On the Analyzer, select the DEFIB function.
8.3 On the Analyzer, select ENERGY.
8.4 Connect the Propaq MFC connector to the
pads connection.
8.5 On the Propaq unit, apply power to the unit
using a battery or an AC adapter.
8.6 Connect the MFC cable to the Propaq unit.
8.7 Turn on the Propaq unit, and press the Leads
quick access key
( )
to select PADS .
8.8 On the Propaq unit, set energy level to 5J by
pressing the Energy Select DOWN arrow.
8.9 On the Propaq unit, press the CHARGE
button.
The unit charges to 5J, the red
Shock button illuminates and a
ready tone sounds. o o
8.10 On the Propaq unit, press the Shock button.
8.11 On the Analyzer, observe and record the
energy measurement.
Energy is delivered at 5J. Verify
that the delivered energy is within
15% based on the impedance
values of your analyzer in the
table “Delivered Energy at 200J
Defibrillator Setting into a Range
of Loads” on page 24. o o
8.12 On the Propaq unit, set the energy level to
50J by pressing the Energy Select UP arrow.
8.13 On the Propaq unit, press the CHARGE
button.
The unit charges to 50J, the red
Shock button illuminates and a
ready tone sounds.
o o
I, II,
III...