Zmorph 2.0 S, User Manual

Page: 28 / 83

GET STARTED / FIRST PRINT
28
Make sure your table is sticky enough (apply „ABS juice” in case of
ABS plastic, or paper glue in case of PLA. You can also use Kapton or blue masking tape
- PLA only. It is possible to print on pure glass when using PLA - requires higher temperatu-
re, 75°C ). If using Buildtak - you don't have to apply anything, it just sticks.
Video below shows how to apply ABS juice on the glass.
Home all axis (first X, then Y and Z).
2
YOUR FIRST PRINT
To test the printer, you should:
1
https://vimeo.com/80748630