Zmorph 2.0 S, User Manual

Page: 17 / 83

GET STARTED / CALIBRATION
17
If there is something wrong with
the homing procedure (if the endstops
are too low, or rotated/moved because
of transport)
press RESET immediately
or disconnect the machine. Otherwise
the toolhead might go too low and colli-
de with the print surface.
2
TESTING THE AXIS
After checking the endstops
and making sure that nothing blocks
the axis mechanisms (belts, pulleys etc)
click the button marked with X in Voxe-
lizer.
Or alternatively, use panel:
OK >> Calibrate >> Home X Axis
The toolhead carriage should go
left and stop.
3
Important : Before you
start testing the axis, make sure that
endstop for Z axis is in correct position
(approximately).
It might have moved
during transport. It must be positioned
in a way, that allows contact with
the tactile switch, when in lowest
possible position.
!
1