Zmorph 2.0 S, User Manual

Page: 23 / 83

GET STARTED / CALIBRATION
23
Changing the height of the working table (not recommended unless you know
what you’re doing) made by turning screws in the glass plate with a Philips nr. 2
screwdriver. A half rotation of the screw results in about 0.35mm difference.
If you have a difference between left, and right half of the table you should first check
the table corner heights by using a ruler (right side picture).
Generally, these changes are not required by the first use, as the machine comes
calibrated - slight differences might occur due to transport or unpacking.
If you are experiencing any problems with balancing the table or X axis of the machine,
consider purchasing the clip-on add-on for the ZMorph called
Touch Probe.
It will make calibration much easier and is available in our shop.
Video tutorial demonstrating this can be found here: https://vimeo.com/118746466
B