Chapter 1: Installation overview
ZP3 Fire Control Panel Installation, Commissioning, and Maintenance Manual
29
To prevent electric shock, do not remove the cover of this module
while the unit is powered up. There are no user-serviceable parts inside. Only an
approved maintenance authority may perform servicing work.
Do not overtighten the panel clamp screws. Failure to comply will
damage the unit.
Make sure the associated washers are positioned directly beneath each
screw head.
1. See Figure 21 on page 30. Fit the Modem mounting bracket (item 3) onto the
four accessory plate stand-offs (item 2) and secure using the four M4 screws
(item 5) supplied, with associated washers (item 6) positioned directly
beneath each screw head.
2. See Figure 22 on page 30. Position the Modem on the mounting bracket so
that the Modem catch is positioned in the upper tab of the mounting bracket.
3. Push the lower corner of the Modem in the direction of the arrow so it locks
into position on the mounting bracket.
4. See Figure 23 on page 31. Fit the accessory plate (if necessary) to the ZP3
panel.
5. Connect the 9-way RS-232 cable from the modem connector to connector
JP3 on the ZPAB-RS232 board located on the ZP3 panel.
6. Connect the telephone line to the RJ11 socket on the modem.
7. C24 VDC supply from the modem power supply connector to the
+24V and 0V connections on the Supply Output connector located on the ZP3
panel main board.
Summary of Contents for ZP3
Page 163: ......
