806834 v1.02 07.21 G5 Online install instructions and user guide
65
• Follow filter flush procedure , page
Section 5 Commissioning
5.4 Filter flush
12:12 PM
TANK FLUSH
Follow the prompts to flush fresh water through the
tank/s 3 times as shown by the cycle counter/s.
The tank/s will fill automatically but when
prompted use the tap to dispense and empty.
Dispense water from the hot tank using the taps
safety feature.
5.5 Tank flush
(does not apply to chilled sparkling models)
• Upon first use, the HydroTap water tanks must be flushed
with fresh water.
• Follow the instructions to flush the tanks. Dispense water
from the tap as instructed.
• Note
Once the tank is full it is necessary to empty each
tank until the HydroTap starts to fill again. If the tank is not
emptied completely the tank flush will not be complete and
will time out. This requires the commissioning process to be
started again.
5.3 CO
2
purge
(sparkling models only)
• See page
.
• Touch the arrow to continue , when ready to start using the
HydroTap.
5.6 Boiling calibration
(boiling models only)
• Press the green button and the system will start the boiling
calibration procedure. This will take approx. 5 to 6 minutes.