806834 v1.02 07.21 G5 Online install instructions and user guide
105
USER GUIDE
• The HydroTapG4 air filter is conveniently
located on the outside of the condenser.
• The filter screen is a sliding fit in the plastic
housing on the left hands side of the Command
Centre.
• The screen may be removed for cleaning by
sliding it forward.
• This needs to be inspected at least quarterly,
cleaned and replaced if damaged.
• Rinse off with tap water.
• Gently dry with a cloth or towel.
• Note
For best performance the unit should
only be operated with a clean air filter screen,
correctly fitted in place.
• Maintain at least a 50mm air gap in front of the
screen at all times.
• Take care not to allow cloths or other soft
materials to accidentally block the air inlet.
4.1 Filter maintenance
continued
Air inlet filter maintenance
4.1.2 Air inlet filter maintenance
Slide forward to remove.
4.2 Cleaning
!
!
• Wipe surfaces with a damp cloth or antibacterial
alcohol wipes, then wipe dry with a clean, dry
microfibre cloth or paper towel.
• Food-grade disinfection wipes may be used to
clean around and within the tap spout.
!
• Do not use abrasives to clean the sensor lenses
at the sides, top and rear of the tap.
• This could cause permanent malfunction and
void warranty.
Rinse off with tap water.
Touch-Free Wave Tap
Section 4 User maintenance
!
!
IMPORTANT
!
!
• Do not use strong, corrosive, or abrasive
cleaning materials.
• Do not use air-drying disinfectant sprays.
• Failure to remove the cleaning liquid may
damage the finish of the tap.
