Zingui
40
6.1.2 Brightness
1. Go to T
Tools > Zingui and select Settings.
The window S
Settings appears on the screen.
2. Displace the slider till you obtain the desired brightness.
3. Enable A
Automatically Adjust Brightness if you want the Zingui to adapt
automatically the brightness (with a maximum of the set brightness) of the
screen depending on the exterior brightness. This option is useful to use
the energie efficiently and to extend battery life.
6.1.3 Standby and Shutdown Delay (requires restart to update)
Changed settings will be operational after restarting the Zingui.
1. Go to T
Tools > Zingui and select Settings.
The window S
Settings appears on the screen.
2. Turn off display after: Never - 1 minute - 90 seconds - 2 minutes - 3
minutes - 5 minutes - 10 minutes if you want the display to be
automatically turned off after a specific time of inactivity.
3. Standby after (after turning off display): Never - 2 minutes - 5 minutes - 10
minutes - 15 minutes - 30 minutes - 1 hour. After the screen has been
turned off, you can ask the Zingui to go automatically in stand by mode
after a specific time of inactivity.
4. Shut down after (after going to Standby): Never - 5 hours - 10 hours - 20
hours - 25 hours. After the Zingui has been put in stand by mode, you can
ask the Zingui to be shut down automatically after a specific time.
5. Select OK to confirm and restart the Zingui to activate this settings.
6.1.4 Zingui Control Using button 1
1. Go to T
Tools > Zingui and select Settings.
The window S
Settings appears on the screen.
2. Turn on device when holding the switch: Never - 1 second - 2 seconds - 3
seconds - 4 seconds - 5 seconds - 6 seconds - 7 seconds - 8 seconds - 9
seconds.
3. Shut down device when holding the switch: Never - 1 second - 2 seconds -
3 seconds - 4 seconds - 5 seconds - 6 seconds - 7 seconds - 8 seconds -
9 seconds.
6.2 Clean Up Disk
When you record several wave files under a specific cell, the wave files that are
not in use are still stored on the flash disk of the Zingui. When the hard disk is
getting full, you can clean up the disk. The option C
Clean Up Disk will erase all the
wave files that are not linked to a cell.
1. Go to T
Tool > Zingui and select C
Clean Up Disk.
Summary of Contents for Zingui Plus
