ZIEHL-ABEGG Fcontrol FKDM..-C Series, Operating Instructions Manual

Page: 28 / 99

9 Programming
9.1 Speed controller 1.10 ... 1.11
9.1.1 Basic setting 1.10 ... 1.11
Main menu
Base setup
Setting
Protocol
Base setup
Controller Setup
IO Setup
Base setup
Mode
Factory setting Mode: 1.10
1.10
Mode
Base setup
E1 Analog In
Selection: 0 - 10V, 0 - 20 mA, 4 - 20 mA (Inverting, E1 BUS Modus IO Setup)
Factory setting: 0 - 10 V
0 - 10V
E1 Analog In
Base setup
E2 Function (only for special applications)
Analog input 2
“
E2
”
factory set at
“
OFF
”
.
For operation with a second setting signal and switch over by potential-free contact: E2
Function = Ext. Setpoint (1E)
Necessary function for digital input: E1/E2 (4D)
IO Setup
For operation with a second signal and automatic control at the higher level: E2
Function = comparison E1 (4E).
OFF
E2 Function
Base setup
E2 Analog In
Display as long as no function allocated:
|
- - - - -
|
Selection: 0 - 10 V, 0 - 20 mA, 4 - 20 mA (Inverting, E1 BUS Modus IO Setup)
Factory setting: 0 - 10 V
- - - - -
E2 Analog In
9.1.2 Setting for operation modes 1.10 ... 1.11
Attention!
To ensure that the compressor also has adequate lubrication, it is essential to note the
minimum speed de
fi ned by the manufacturer.
Main menu
Setting
Setting
Protocol
Base setup
Controller Setup
IO Setup
Setting
Set Intern1
Setting range manual speed setting:
“
Min. Speed
”
-
“
Max. Speed
”
Factory setting:
Mode
1.10 = 50.0 Hz
Mode 1.11 = 50.0 Hz
50.0 Hz
Set Intern1
Operating Instructions Fcontrol
–
model series FKDM25/32AM-C Programming
L-BAL-E214-GB 1446 Index 002 Part.-No.
28/99