Ziegler PKT 452, Original Operating Instructions

Page: 40 / 64

40
4. Assembly
a) Mounting of the Nozzle Holders
In order to be able to mount the nozzles to the auger tube, two bore holes with
approximately 20 mm Ø must be drilled at the auger tube directly following the intake
funnel (see Page
–9-).
Before the nozzle mounting plates are fastened using four tightening straps, they
must be screw-connected with the nozzle holder.
Beforehand, the ball valve filters and the required nozzle combination must be
inserted.
After having drilled the bores (see diagram Page
–9-) at the auger tube, the nozzle
holder is braced with two nozzle mounting plates and the rubber sealing plates using
four straps and the turnbuckles to the auger tube (see Diagram 1).
The tightening straps should be placed directly adjacent to the hexagon nut of the
nozzle mounting plate as displayed in the diagram (see Diagram 1).
The four tightening straps, which are included in the delivery scope, are dimensioned
in length to be suited to fit for a tube diameter of 250 mm (see Page 41 Tensioning
Strap Sizes).
Diagram 10
Diagram 11
Tightening Strap
Slotted Hole
For ightening
Strap
Turnbuckle
Tightening Screw
SW 5
Rubber Sealing
Plate
Tightening Strap
with slanted
Perforation
Nozzle Holder
Auger Tube
Nozzle Plate
Tightening
Strap
30