QUICK USER MANUAL
2
EN 3329.758.704 - 2017-01
•
On
Y
axis:
•
On
X
axis:
•
On
Z
axis:
The ship goes around the centre of rotation.
COMBINED MOVEMENTS
Push joystick first, then rotate the knob in the desired directions.
•
For example: AHEAD MOVEMENT AND RIGHT TURN
•
For example: ASTEARN MOVEMENT AND LEFT TURN
Pushing the joystick sideways, the boat moves sideways.
In case the boat doesn't move parallely, you can correct this move-
ment by rotating the knob in the direction you want to correct.
While manoeuvring with the joystick, the control lever must stay in
neutral position. If in manoeuvring mode you unvoluntarly put the lever
in Forward or in Reverse, this doesn't have any effect and the joystick
is still active and working.
When you release the joystick control (by pushing the joystick button)
the boat will not still perform any action. In fact, for your safety, the
diesel engine will remain at idle speed and the transmission in neutral.
To regain control of the lever you have to put the control lever in the
neutral position. Only after that the system will allow you to engage
the transmission and raise the engine rpm by moving the control lever.
Fig. 1 STRAIGHT AHEAD MOVE-
MENT
Fig. 2 STRAIGHT ASTEARN MO-
VEMENT
Fig. 3 SIDEWAYS LEFT MOVE-
MENT
Fig. 4 SIDEWAYS RIGHT MOVE-
MENT
Fig. 5 COUNTERCLOCK WISE
ROTATION
Fig. 6 CLOCKWISE ROTATION
OPERATING CONDITIONS
CTRL LED
READY LED
System Off.
Off
Off
System On (Engine Panel tur-
ned on).
Off
On (Red solid)
Drive/Warmup Mode active
(Engine turned on).
Off
On (Red solid)
Maneuver Mode active - Joy-
stick in neutral position.
On (Green
solid)
On (Green solid)
Maneuver Mode active - Joy-
stick out of neutral position.
On (Red
solid)
On (Green solid)
Maneuver Mode active - errors
present.
On (Green
solid)
On (Red blinking)
Maneuver Mode not active - er-
rors present.
Off
On (Red blinking)
IMPORTANT:
If the ready LED is blinking red it may be either:
A - a warning is present and the system mantains its full or partial
functionalities
B - an error is present and some or all of the system functionalities
are disabled. You can try to recover full functionalities by a re-bo-
oting, as described in stand-by mode section
In any case for any kind of malfunctioning of the sy-
stem, you can try to recover functionalities by a re-
booting, as described in Stand-by Mode section.
