Zeta NPAD 2, Installation Manual

Page: 18 / 33

PREMIER AD INSTALLATION MANUAL.
Software:PANEL:R1107 & LOOP:R1062
Approved Document No: GLT.MAN-105A
PAGE 17
Issue : 2.02 Authorised: GH Date: 16/07/2007
10. FIELD DEVICE TERMINATION
10.1 TERMINATING THE WIRING.
LIVE NEUT- EARTH
RAL
M
A
IN
S F
USE
3A
H
B
C
C
E
RA
M
IC
47
W
/7
47
W
/7
47
W
/7
47
W
/7
47
W
/7
47
W
/7
CONN19 CONN12 CONN20 CONN13 CONN21 CONN14 CONN22 CONN18 CONN15 CONN16 CONN17 CONN28 CONN24 CONN25 CONN23
CONN27
CONN4
CONN6
CONN29
CONN30 CONN2
CONN27
LOOP 1A
- +
SND 1
- +
LOOP 1B
- +
SND 2
- +
LOOP 2A
- +
SND 3
- +
LOOP 2B
- +
SND 4
- +
FIRE RELAY
NO CM NC
SERIAL RE PAETER
- + - +
AUX SUP
- +
CLASS CH
- +
FAULT RELAY
NO CM NC
+ -
BATTERY
AC AC
INLET MAINS
SUPPLY
Brass Glands
Figure 6: Detector and Sounder Circuit Connection
11 OTHER CONNECTIONS
11.1 REPEATER CONNECTION
The Premier AD has an RS485 connection for a serial repeater. The repeaters are display only (no
control). A single repeater can be powered from the panel`s Auxiliary Supply. If 2 or more are to be
connected, then they must be powered from external 24V power supplies. The panel supports up to 4
repeaters.
Connections
Premier AD (Termination PCB) AD Repeater
SERIAL RE COM-
SERIAL REPEATER - COM +
AUX SUP + +28V
AUX SUP - 0V
11.2 SERIAL PRINTER CONNECTION
The Premier AD has a connection for a serial printer. The printer will print out panel events as they
occur. The recommended printer is an Epson LQ300 II+. The serial port on the Premier AD is
configured to this printer`s default settings.
Connections Serial Port Settings
Premier AD 25 pin D connector Setting Value
TX Pin 3 (RX) Baud Rate 19200
RX Pin 2 (TX) Data Bits 8
GND Pin 7 (GND) Stop bits 1
CTS Pin 4 (RTS) Parity NO
DSR Pin 20 (DTR) Flow Control Hardware
MAKE SURE ANY SPARE
ENTRY HOLES ARE
COVERED WITH THE
GROMMETS PROVIDED
All cables entering the enclosure
should have brass cable glands,
which will ensure a good ground to
the steel EMC cable grounding plate.
The Detector and Sounder circuits
should be connected to the
appropriate connector block on the
Termination PCB as shown in Figure
6 below.
All screens should be terminated at
the brass earthing strip as shown in
Figure 6
(For detailed detector and alarm
circuit wiring diagrams, please refer
to pages 4 and 5.)