ZoningBOX 6 / ZoningBOX 4
Technical Support:
39
ETS PARAMETERISATION
The
Manual Control
is configured from the Configuration tab itself under Manual
Control, as long as this function has been enabled in General (see section 2.1)
Figure 27.
Manual Control
As the only manual control mode available in this device is the Test On mode, it will get
enabled simply by enabling the manual control function. Thus, only one parameter
must be parameterised:
Manual Control Lock
[
disabled
/enabled
]: provides an optional procedure for
locking the manual control in runtime. When this checkbox is enabled, object
“
Manual Control Lock
” turns visible, as well as two more parameters:
➢
Value
[
0 = Lock; 1 = Unlock /
0 = Unlock; 1 = Lock
]: defines whether the
manual control lock/unlock should take place respectively upon the
reception (through the aforementioned object) of values “0” and “1”, or the
opposite.
➢
Initialization
[
Unlocked / Locked /
Last Value
]: sets how the lock state of
the manual control should remain after the device start-up (after an ETS
download or a bus power failure); (default option; on the very first start-up,
this will be Unlocked).
