Zenith D56W25, Operating Manual & Warranty

Page: 8 / 56

VARIABLE
AUDIO OUT
R
L
ANTENNA/
CABLE 1
ANTENNA/
CABLE 2
TO CABLE
BOX
INPUT 1 INPUT 2
S-VIDEO S-VIDEO
MONO/L
R
MONO/L
R
VIDEO VIDEO
AUDIO
AUDIO
MONITOR
OUT
S-VIDEO
L
R
VIDEO
AUDIO
INPUT 3
INPUT 4
Y/VIDEO
P
B
P
R
R
MONO/L
AUDIO
Y/VIDEO
P
B
P
R
R
MONO/L
AUDIO
Over-the-Air
Antenna
RF Coaxial Wire
(75 ohm)
Antenna
Cable TV
Wall Jack
Cable
Service
RF Coaxial Wire
(75 ohm)
206-3489-O
P A G E 8
Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
on one end and a round opening with a wire sticking out on the other end.
Hook Up Direct Cable TV or Antenna
Connect an off-air antenna
300 TO 75 OHM
ADAPTER
1
2
3
Locate the Antenna/Cable 1 jack on
the back of your Entertainment
Machine.
Connect the cable that runs from
the wall directly to this jack.
Turn to page 15 to continue setting
up your Entertainment Machine.
If you receive your RF signal through an
antenna that is several years old and con-
nects with two small prongs, you will need
to purchase a 300 to 75 Ohm adapter. It
should be available from your local
electronics dealer.
Zenith recommends using a 75 Ohm cable
for your antenna connections in order to
prevent interference.
OR