Zenith D56W25, Operating Manual & Warranty

Page: 43 / 56

P A G E 4 3
206-3711
1 2 3
4 5 6
7 8 9
0
mute
vol ch
flshbk
pause rew
f f
play
record stop
skip
CC
quit
split
tv vcr
power
dvd hd/stb
cable
menu
multi
tv
vcr cable
hd/stb
light
dvd
sleep
mode
aspect
c skip pip ch
display
fav ch
theatr
source
The device you want to program the remote to
operate should be turned ON.
On the next two pages are the Name Brand Product
Programming Codes, find the type of device you’re
programming and then find the brand name. Write
down the three-number codes.
Push the mode key with the name of the device
you’re programming (VCR, CABLE, DVD, HD/STB).
Hold down the mode key (VCR, CABLE, DVD,
HD/STB) until the indicator light turns on, continue
holding down the mode key.
Using the NUMBER keypad, enter the three-number
Brand Code found in the chart on the Brand Code
reference pages (following two pages). The indica-
tor light will flash three times and turn off if the
code was accepted. Release the mode key.
Point the remote at the device and press the
POWER key. The device should turn off. If not, try
the other 3-number codes listed and continue from
step three.
Your Zenith remote control may not operate all devices.
1
2
3
4
5
6
Indicator Lights
6
7
4
5
Programming the Remote
Program your remote to operate a variety of Audio/ Video devices
Mode / Product Compatibility
TV VCR CABLE DVD HD/STB
TVs VCRs Cable Boxes, Audio CD, Video Disk Set top
Satellite Audio Tape Decks Boxes
Receivers Audio Tuners
Audio Amplifiers
3
4