8
HDVI5 Component Video Switch
HDVI5 Component Video Switch
Using a Different Remote
The HDVI5 features Zektor ’s Exclusive Intelligent-IR™, and with ver y
few exceptions can be setup to use any remote you can point at it!
This is useful if you have more than one HDVI5 in the same room.
Pick a new remote
Star t by pick ing a new remote you’d like to use with the
HDVI5. (Or use the unused buttons on the HDVI5's remote.)
If you plan on using a universal remote, star t by setting
it up as a remote for a T V or VCR that you don' t own. (For
instance if you don’t own a Sony T V, setup your universal
remote to control a Sony T V.)
Step 1: Put the HDVI5 into the Setup Mode
The HDVI5 is placed into the setup mode by pressing and
holding the Power button for about seconds.
Step 2: Select the Intelligent-IR™ Learn Mode
Select the Intelligent-IR™ Learn Mode pressing ‘’.
Once the ‘’ button is pressed, the standby LED will flash
slower and all the other LEDs will turn off. The HDVI5 is
now waiting for new IR codes to be sent from your remote
control.
Step 3: Teach the HDVI5 your new remote control codes
On your remote control, press the following buttons, in the
following order:
Power 1 2 3 4 5 0 8 9
The front panel LED's will sequence as each button is
pressed, and the IR LED will flash for each button -- if not,
see the following section on
"More Remote Options".
That ’s it! The HDVI5 will return to the state it was in before
setup, and will now work with your new remote!
The new control buttons on your remote are...
Power
Toggles the HDVI5’s power.
1 - 5
Selects inputs through 5.
0
Sequences the SEL button (A/V break away).
8
Toggles Auxiliar y Relay .
9
Toggles Auxiliar y Relay 2.
Note:
All remote control codes are saved in non-volatile
memor y and will not be lost during a power failure.
•
•
•
•
•
•
•
•
1 2 3 4 5 SEL A1 A2
Step 1: Put the HDVI5 into the Setup Mode
Press and hold the Power Button for secs.
The front panel LEDs will start to blink
wildly... (You’ll know it when it happens!)
Step 2: Press the ‘1’ button for Intelligent-IR™ learning
1 2 3 4 5 SEL A1 A2
Step 3: Teach the HDVI5 its new IR codes
1 2 3 4 5 SEL A1 A2
1 2 3
4 5 6
7 8 9
0
+ +
_ _
POWER
VOL
CH
Press the following sequence of buttons on
your remote control:
Power 1 2 3 4 5 0 8 9
That’s it! The HDVI5 now operates with
your new remote control!
Once the button is pressed, the
standby LED will flash slower, and
all the other LEDs will turn off.
