30
HDVI5 Component Video Switch
3
HDVI5 Component Video Switch
Relay Options (Cont'd)
Toggle and Momentary Relay Modes
If all channel LEDs are off, then the relay will not be affected by
changing channels. The 'SEL' button is used to switch between the
Toggle Mode and the Momentar y Mode.
Toggle Mode
In the Toggle Mode (the blue 'SEL' LED is lit) the relay will toggle
between On and O ff each time the relay button is pressed. All relay
delay times are ignored in the Toggle Mode.
Use the 'SEL' button to switch to the Toggle Mode (Blue
'SEL' LED lit).
Momentary Mode
In the Momentar y Mode (the red 'SEL' LED is lit) the relay will ac-
tivate when it's button is pressed, and then turn itself off after a
programmed amount of time. Use the 'SEL' button to switch to the
Momentar y Mode (the red 'SEL' LED is lit).
Use the 'A' and 'A2' buttons to adjust the amount of time
the relay is active before turning itself off. The delay times
are indicated by the top row of blue LEDs and correspond
to the following times:
No LEDs lit
= Same as Toggle Mode
•
One left justified LED
= / seconds
••
Two left justified LEDs
= /2 seconds
•••
Three left justified LEDs
= seconds
•••• Four left justified LEDs
= 5 seconds
••••• Five LEDs
= 0 seconds
•••• Four right justified LEDs
= 30 seconds
••• Three right justified LEDs
= minute
•• Two right justified LEDs
= 5 minutes
• One right justified LED
= 0 minutes
•
•
1 2 3 4 5 SEL A1 A2
Toggle Mode
1 2 3 4 5 SEL A1 A2
Momentary Mode
All channel LEDs are turned off.
The blue 'SEL' LED is lit.
Delay Times are ignored.
Blue LEDs indicate delay times.
A = Decrease delay
A2 = Increase delay
All channel LEDs are turned off.
The red 'SEL' LED is lit.
Press Pwr Button to
exit setup mode.
Press Pwr Button to
exit setup mode.
