Set-up
Carl Zeiss
Inserting or removing the stop slider
Fluar Illuminator Z mot.
16
435180-9060-701
05/2012
•
Once the configuration of the reflector turret has been completed, replace the cover (Fig. 5/
4
). To do
this, insert it into the dovetail guides on the underside of the Fluar Illuminator Z mot. and push until it
engages. Make sure it has a precise fit, so that the safety contacts are closed.
•
If reflector modules without automatic component recognition are used, apply the supplied stickers
marked with the fluorescence filter combination used to the fields provided beneath the
corresponding control key (Fig. 6/
1
) and configure as necessary in SYCOP 3.
3.5
Inserting or removing the stop slider
The stop slider is supplied in a manual or motorized version.
Both types are inserted in the Fluar Illuminator Z mot. in the same way. However, the procedure for
removal is different.
The mounting bay for the diaphragm slider is located on the left-hand side of the Fluar Illuminator Z mot.
Inserting the stop slider
•
Remove the blind cover (Fig. 6/
6
) from the
diaphragm shaft of the Fluar Illuminator Z mot. To
do this, press the two latching nipples (top and
bottom) together in the direction of the arrow
and remove the blind cover.
•
Insert the slotted cover (Fig. 6/
3
) instead of the
blind cover. To do this, first insert it into the
recess on the Fluar Illuminator Z mot. with the
latching nipple (Fig. 6/
2
) on the upper side and
press the underside carefully until the lower
latching nipple engages. Exert only slight
pressure to prevent the cover from being
pushed in too far and becoming jammed.
•
Insert the stop slider (manual (Fig. 6/
4
) or
motorized (Fig. 6/
5
)) into the slit and push it until
it engages. The locking element of the stop slider
will point downwards.
Fig. 6
Inserting the stop slider
Summary of Contents for Fluar Illuminator Z mot.
Page 1: ...Operating Manual Fluar Illuminator Z mot for Axio Zoom V16...
Page 2: ......
Page 22: ......
