![background image](http://html1.mh-extra.com/html/zeiss/cl-6000-led/cl-6000-led_operating-instructions-manual_3306370027.webp)
CL 6000 LED- | CL 9000 LED-Bedienungsanleitung
27
Stand Oktober 2015
3 Start up
3.1 Light guide holder
Rotate the collet chuck of the light guide holders (4) in counter-clockwise direction to open the collet chuck. Push the light guide
into the light guide holder to its limit-stop and rotate the collet chuck (4) in clockwise direction to close it and to ensure that the light
guide is fi rmly positioned. Light guides with guide pin: Make sure to insert the guide pin into one of the guiding slots. Please use
only original fi bers which are approved for the light sources CL 6000 LED and CL 9000 LED by Carl Zeiss
CAUTION! The light guide holder (4) is equipped with a safety shutdown to protect the user from dazzling. If the
light guide is inserted into the light guide holder incorrectly or not all the way to the limit-stop, the light of the
light source will not start when switched on, and the message „Light Guide!“ is shown in the display.
3.2 Mains connection
Push the barrel connector of the power cable (supplied with the device) into the respective connection socket (13) at the device
rear. Use the cold light source only with the power cable that was supplied with the device. Connect the plug connector of the cold
device cable to the power supply.
Other country-specifi c variants of the power cable are available from Carl Zeiss. Furthermore every commercially available power
cable which meets with standards and specifi cations can be used.
3.3 Start-up of the device
Switch on the cold light source by actuating the main switch (1). The LCD display (3) of the cold light source is active in switched-
on condition. When used the fi rst time, the cold light source starts with an intensity of 0%. Upon each new switch-on, the light
source starts with the intensity setting of the prior use.
3.4 Switching off the device
Switch off the cold light source by actuating the main switch (1) (all-pole power disconnection). The device will not consume any
power in the switched-off mode.
CAUTION! Pull the mains plug for safe disconnection of the device from the power supply!