CL 6000 LED- | CL 9000 LED-Bedienungsanleitung
Stand Oktober 2015
28
4 Operation of the light source
4.1 Brightness settings and adjustment
Rotate the encoder (2) in order to adjust the intensity (up: clockwise direction; down: counter-clockwise direction).
By repeatedly briefl y pressing the rotary encoder (2) the intensity can be adjusted in pre-set stages of 0, 20, 40, 60, 80 and 100
(factory pre-settings).
A menu can be accessed by pressing the incremental encoder (2) for at least 3 seconds. The menu navigation is shown in the
LCD display (3). In the menu, individual intensities in 6 memory locations can be set and stored.
In addition, fi ne setting of the rotary encoder can be determined by the user, to be chosen from the following settings: coarse (25
steps), medium (50 steps) and fi ne (100 steps).
The factory settings of the device can be re-instated.
The menu functionality is explained in detail in Chapter 4.3 „Setup menu and LCD display“.
CARL ZEISS
CL 6000 LED
CL 6000 LED
Light: 0
CL 6000 LED
Light: 33
Display indication directly after switch-on.
The display changes after a few seconds.
(Also applicable to CL 9000 LED)
Intensity set to Zero.
Rotate the incremental encoder (2) to change the in-
tensity e.g. to 33. (Also applicable to CL 9000 LED
Intensity has been set to 33t.
Rotate the incremental encoder (2) to change the inten
4.2 Memory storage stages
By repeatedly briefl y pressing the rotary encoder (2), successively stored brightness levels which were saved in the device‘s 6 me-
mory slots can be accessed. The factory settings are 0/ 20/ 40/ 60/ 80 and 100. The memory slots can be programmed individually
in the setup menu. Each of the 6 memory slots can be assigned brightness values from 0 to 100 or can be completely switched
off so that the respective storage slot will not be accessed when the rotary encoder (2) is pressed.
Example:
To quickly switch between the maximum brightness level 100, dimmed brightness level at stage 25 and „light off/no brightness“,
the 6 memory slots can be programmed as follows:
Mem 1 -> 100
Mem 2 -> 25
Mem 3 -> 0
Mem 4 -> OFF
Mem 5 -> OFF
Mem 6 -> OFF
By repeatedly briefl y pressing the rotary encoder (2), the following sequence is activated:
100 -> 25 -> 0 ->100 -> 25 -> 0 ->100 -> 25 -> 0 ->100 -> 25 -> 0 ->…
The functionality of the menu is described in detail in Chapter 4.3 „Setup menu and LCD display“.