ZyPer4K-M
User Manual Revision 2.5
Installation Environment
The general area where the ZyPer4K unit is to be installed shall be clean and free of
obstructions or clutter.
Mounting Options
•
Unit may be mounted horizontally on the installed rubber feet
•
Unit may be bolted to a horizontal surface using the provided L-brackets with or
without feet installed.
•
Unit may be mounted vertically only if appropriate clearance is provided around the
grille work for adequate airflow. The appropriate ZyPer4K rack mount kits insure that
airflow space is sufficient when mounting vertically.
•
Units may be stacked in a horizontal orientation providing stack is no higher than 3
units when using the provided rubber feet
-
Greater stacking requires that the user remove the rubber feet and externally
bracing the stack of units.
•
In all cases, insure that the units are rigidly held in place and will not be subject to
impact and there is no possibility of toppling.
•
Do not stack any other equipment or devices on top of the unit weighing more than
3Kg and only if sufficient bracing is provided to protect against toppling.
WARNING: Failure to adhere to these recommendation could result in
unsafe operation, damage to the equipment, or injury to the operators.
Mounting Brackets
ZyPer4K-M equipment may be used horizontally and simply sit upon the rubber feet that are
factory installed. It is recognized that in some sites a more rigid and secure installation is
desired. To that end, each ZyPer4K-M device is supplied with two L-shaped brackets which
may be optionally used to rigidly affix the unit to a shelf, wall, or any sturdy surface.
The brackets are supplied in a separate polyethylene bag included in the packaging for the unit.
It is up to the installer to provide the appropriate screws or bolts to affix the unit to whatever
surface it is to be mounted.
User Manual
Page
of
24
53
