4
5
User ManUal
OPeraTInG InsTrUCTIOns
Please read the operating instructions before using this device.
Only use the device as described in these operating instructions.
Keep these instructions for future reference.
a connected charger. This reduces the internal
batteries wear thus extending the life of Pri-
merCube significantly.
We only recommend using PrimerCube powe-
red by batteries for a short time (3–5 hours)
The charging proceeds as follows: after co-
nnecting the USB charging cable and the
adapter to the power supply, connect Primer-
Cube to the charger. The charging process is
indicated by a red control light located next to
the USB connector. The first charging should
take at least 8-10 hours. The display shows the
battery status and the charging process status.
The battery charging process is fully automa-
tic, and the charging process ends automatica-
lly when the battery is fully charged.
We recommend using PrimerCube during
charging when possible. It can also be used
temporarily with an internal battery.
DIsPlaY FUnCTIOns
anD DeVICe OPeraTIOn
1: Display activation
Connect the original charger to the USB power
connector on the PrimerCube and charge it for
at least 8–10 hours.
Hold down the START = / Zzz / button on
the upper left corner of the display for 5-7
seconds. When pressed properly, the red LED
will start flashing – wait until the display lights
up.
PaCKaGe COnTenTs:
1x Primer Cube rotary magnetic oscillator
1x USB-C charging cable
1x 5V 2A USB charging adapter
1X operating instructions
PrIMerCUBe FUnCTIOn:
The rotary magnetic oscillator is functionally
adjustable with the high accuracy of the se-
lected speed. Choice of speed in the interface:
900–3500 Rpm/min
Note: Rpm – Revolutions per minute
The device has a built-in button for setting the
application time; the application time can be
selected in three time intervals.
Warning: The PrimerCube device is sensitive to
shocks. It has a built-in motor with a rotating
pan equipped with permanent neodymium
magnets. This pan rotates at high speed. Make
sure to avoid any blows and shocks!!!
The purpose of the device: laboratory use,
physical experiments with a magnetic rotating
field.
BaTTerY CHarGInG PreCaUTIOns
The device batteries must be fully charged
before using the PrimerCube for the first time.
When charging the battery for the first time,
charge the PrimerCube for at least 8–10 hours.
Subsequent full charging of the battery will
take approximately 3-5 hours. The type of
battery built in PrimerCube: 8,8 A / h Li-ION.
This type of battery has no memory function.
Consequently the battery can be charged at
any capacity phase, it is not necessary to dis-
charge the battery completely in order to be
charged.
Discharging the battery completely shortens
the battery life!
OnlY Use THe OrIGInal CHarGer sUPPlIeD
WITH PrIMerCUBe!
It is recommended to use PrimerCube with
ENGLISH
