45
FITTING INTO THE SPACE BETWEEN
CABINETS
IMPORTANT: Ensure that the oven is switched off
at the wall before any further work is carried out.
•
Position the appliance in front of the cabinet. See Fig.
12.
•
Take out all oven furniture before installation to reduce
the weight you need to lift. The oven door should be
taped to keep it closed whilst lifting.
•
To place the appliance into the space between
cabinetry follow the procedure below:
•
N.B. Two people will be required to carry out the
lifting procedure.
Warning: Do not attempt to lift this appliance by the
handle(s).
•
Each person should squat either side of the
appliance.
•
Tilt the appliance so that your hands can support the
underside of the appliance.
•
Keeping your back straight raise the appliance to the
correct height by straightening at the knees.
•
Rest the rear underside of the appliance on the
mounting brackets while your hands support the
front.
•
The appliance can be pushed fully into the space.
Take care to avoid fouling the mains lead.
•
Ensure the appliance is central and level.
•
When the appliance is fully housed, screw the stability
screws (supplied with the appliance) into the
underside of the worksurface in the positions
indicated (see Fig. 13), taking care not to distort the
trim. It is advisable to turn each screw alternatively to
avoid damaging the trim.
•
Place the heat deflector flush with the edge of the
worksurface, with the cork spacers up over (see
Fig.14) and screw into position using the screws
supplied with the appliance. Failure to do so may
cause damage to the underside of the work surface.
•
Replace the plinth board.
•
Switch on the appliance and refer to the operating
instructions.
Fig.14
Fig.13
Fig. 12
