1. Unscrew approximately one turn the bypass
screw position A.
2. Put the knob for the oven functions back.
3. Connect the appliance to the electricity.
WARNING!
Put the mains plug into the
mains socket only if all parts are
back into their initial position.
There is a risk of injury.
4. Light the burner.
Refer to "Oven - Daily use" chapter.
5. Turn the knob for the oven functions on the
minimum position.
6. Remove the knob for the oven functions
again.
7. Screw on slowly the bypass screw till the
flame becomes minimum and stable.
8. Put the knob for the oven functions back.
9. Set the maximum gas flow position on the
knob for the oven functions and let the oven
heat for at least 10 minutes.
10. Quickly turn the knob for the oven functions
from maximum to the minimum gas flow
position.
Control the flame. Make sure the flame does not
go out when you turn the knob to the minimum
gas flow position. There must be a small regular
flame on the oven burner crown. If the flame
goes out adjust the oven burner again.
Gas grill injector replacement
1. Release the screws which keep the grill
burner in position A.
A
2. Release the burner injector with a 7 mm
socket spanner and replace it with a right
one.
3. Assemble the burner in a reverse sequence.
Before you fix the screw, make sure that the
burner is pushed correctly to the back
panel.
Test the grill injectors.
Levelling
CAUTION!
Remove all the accessories from the
oven.
1. Open the lid of the appliance and
disassemble it.
2. Disassemble the pan supports and all the
burner assemblies.
3. Put the appliance on the sidewall on a clean
and smooth surface. Place each foot into a
separate hole, in the plinth, and rotate it
clockwise.
www.zanussi.com
25
