PROGRAMMING EXTA LIFE TRANSMITTERS
• Green “STATUS” LED signals the programming procedure is ongoing.
• Successful completion of a particular operation is signalled by a flashing (several times) orange
STATUS LED.
CAUTION! In SRP-22 receiver, radio push-buttons which must operate in the local and cen-
tral mode, are programmed individually. It is possible to assign up to 96 push-buttons to
one receiver in subsequent iterations of the programming procedure (for example, 48 pairs
in the local mode and 48 pairs in the central mode). It gives a huge flexibility during the pro-
gramming procedure. A receiver responds only to those push-buttons that a user assigned
to this receiver during programming.
• To realise the central mode for some roller blind controllers (simultaneous closing / opening
several roller blinds), it is important to programme the transmitter’s push-buttons in the central
mode to each roller blind controller.
• Push-buttons can be directly assigned to SRP-22 by means of the PROG. button (an access to
a receiver is required) or remotely (without an access to a receiver) by means of the EXTA LIFE
mobile application.
DIRECT PROGRAMMING BY MEANS OF PROG. PUSH-BUTTON
To assign radio transmitters directly to a receiver, use the receiver’s PROG. push-button.
ASSIGNING PUSH-BUTTONS IN LOCAL MODE
(e.g. 2 push-button remote control P-457/2)
1. Press the PROG. push-button shortly (1sec.) in a receiver – STATUS LED switches on blue.
2. In < 5 sec. press shortly this push-button that should realise the local roller blind opening (for
example “1”).
3. STATUS LED switches off and switches on blue again.
4. In < 5 sec. press shortly the button that should realize the local roller blind closing (for example
“2”).
5. The STATUS LED flashes orange to signal the push-buttons have been assigned correctly.
ASSIGNING PUSH-BUTTONS IN CENTRAL MODE
(e.g. 2 push-button remote control P-457/2)
1. Press the PROG. push-button shortly (1sec.) in a receiver – STATUS LED switches on blue.
2. Wait for about 5 seconds till STATUS LED switches on red.
3. In < 5 sec. press shortly this push-button that should realise the roller blind opening function (for
example “1”).
4. STATUS LED switches off and switches on red again.
5. In < 5 sec. press shortly the button that should realise the roller blind closing function (for example
“2”).
6. The STATUS LED flashes orange to signal the push-buttons have been assigned correctly.