REGISTRATION (PAIRING) SRP-22 IN THE EXTA LIFE SYSTEM
In order to register SRP-22 in the system, it is necessary to connect the EXTA LIFE controller in the
system and to install the EXTA LIFE mobile application. The receivers must be connected to 230 V
AC. They are remembered in the system only after they have been properly paired with a controller.
To do it carry out the following steps:
1. Activate the application and enter the Device
screen.
2. Choose the receiver tab and press „+”
to
start the searching process of receivers in-
stalled in the system. It lasts no longer than
60 seconds and can be stopped by means of
the „Stop” push-button. All receivers located
within the controller are automatically dis-
played in a list form with a default icon and
a default name including the receiver’s name
(SRP-22) + 6-digit ID serial number
as-
signed to this receiver.
3. After searching has been completed
,
press the ‘TEST’ push-button to quickly lo-
cate the receiver (press the TEST push-but-
ton alternately so that the roller blind moves
up or down). By marking fields next to the
‘TEST’ push-button
, we choose receivers
to be paired with the EXTA LIFE controller. It
is possible to mark more than one receiver.
4. Press the ‘PAIR’ push-button to pair the
marked receivers. After a while the receivers
are registered in the system and are visible on
the list in the Receivers tab
.
5. After pairing, there is one default icon as-
signed to the SRP-22 receiver.
6. The receivers, just after pairing, can be con-
trolled at once by means of application but-
tons. The receiver’s mode is signalled by the
“Closure level” parameter – given in %. By de-
fault, control is carried out in the close – stop – open mode. The roller
blind movement time is consistent with time configured in the SRP-22
controller.
7. The receivers can be paired individually – press the “PAIR” push-
button and assign a new name to a receiver. In case a larger number of
receivers are paired, they are automatically saved with default names.
8. After pairing, it is possible to add an individual name and icon (from the
icon base) to each SRP-22 receiver.
9. Only after pairing, the receivers can be used in the system in a further
configuration process (assigning a user, a category, building scenes,
time and logic functions).
