ZPrinter
®
650 Hardware Manual
Printer Maintenance
zcentral.zcorp.com
64
All Rights Reserved
10/21/08
3. Lower the retainer.
4. Remove the old Carbon Filter
5. Install the new Carbon Filter with the label at the top and facing out at you as shown.
6. Raise the retainer and latch it closed.
6.5 Clean The Alignment Sensor Window
Frequency:
Clean the Alignment Sensor Window every time you change a print head, or remove a print
head to clean the contacts and pogo pins.
1. On the Control Panel select
BUILD CHAMBER
, then
LOWER PLATFORM
. Continue holding in the
Control Knob until the build bed is about 6” below the top.
2. Pull the Fast Axis toward you and move it out over the build bed.
3. Wet a paper towel with distilled water and wipe off the alignment sensor window on the underside of
the Carriage. The alignment window is located on the front left corner of the Carriage, under the bun-
dle of print head tubes.
Note:
Do not wipe the bottoms of the print heads.
4. Dry thoroughly with a clean paper towel.
