ZPrinter
®
650 Hardware Manual
Printer Maintenance
zcentral.zcorp.com
63
All Rights Reserved
10/21/08
3. Pull the Fast Axis forward until you see the Slow Axis bearing in the center of the opening on the Fast
Axis.
4. Assemble the grease gun that is part of your Accessories Kit according to the instructions.
5. Squeeze the handle until grease dispenses from the tip. Wipe clean with a clean paper towel.
6. Place the tip of the grease gun over the grease fitting. Push down to snap the gun into place on the fit-
ting.
7. Squeeze the trigger 2 - 3 times or until you feel the tension change and then
STOP
.
Do not over-
grease.
8. Unsnap the grease gun from the fitting. Replace the plastic cover.
9. Slide the fast axis forward and backward several times to spread the grease on the slow axis surfaces.
10. Reset the Maintenance Counter in ZPrint.
6.4 Replace the Carbon Filter
Frequency:
When prompted in ZPrint
1. Unlatch and lower the Post-Processing Tray to the bottom of the Post-Processing Unit
2. Press the button to unlatch the Carbon Filter retainer.
