Charging Pile Instructions-V2.0
27
Figure 9.3.1.11
If other vehicle connectors need to be used, click “charging” at the bottom left of charging
information displaying page (see figure 9.3.1.9) and system will back to the homepage (see
figure 9.3.1.1). Then the above steps shall be followed to choose vehicle connector and start
charging process. Charging information of different vehicle connectors could be checked by
clicking “
” or “
” bottons of the charging information displaying page during
charging process.
When system is back to the homepage and customer need to check the current charging
information or stop the charging process, click “settle” at the bottom left of the homepage,
system could jump to the charging information displaying page directly (see figure 9.3.1.9,
figure 9.3.1.10, figure 9.3.1.11.).
6.
Settlement Page
Following step 5, if customer need to stop the current charging process, then swiping the
card at card swipping area (start mode is by card) or clicking “stop charging” at the bottom
of charging information displaying page (start mode is by button) could be chose to stop
charging process and enter settlement page. See figure 9.3.1.12.
When automatic charging mode is chose, charging pile will automatically enter settlement
page after vehicle fully charged. See figure 9.3.1.12. After the self-settlement finished by
charging pile, system will jump back to the homepage and the charging process has been
finished. See figure 9.3.1.1
