73
使用中应经常检查油罐中油量是否缺少，油液有无变质，杂质是否过多，如发现不良
状况，应及时添加或更换。
Frequently check the oil tank for its quantity and the hydraulic oil quality for its
deterioration & impurities. Replenish or change oil in time in case of any
unsatisfactory situations
进回油接头出现漏油现象时不允许采用涂密封胶排除，否则会造成转向泵失效。
Any leakage on the oil inlet & return joints can not be remedied by means of coating
the sealant; otherwise it will result in failure of the steering pump
常见的故障及排除方法：
（表
2-4
）
Table 2-4
Malfunction and solution
现象
Phenomenon
原因
Phenomenon
排除方法
Solution
转向
缓慢、沉重
Slow and pond
erous
steering
油箱内油少
Deficient oil
in oil tank
加 油 至 油 面 高 度
Refill to the level of oil
surface
油液粘度大
Great viscidity of oil
使 用 推 荐 油 液 （
N32—N46
）
Use the
recommended oil(N32—N46)
吸 油 不 畅
Difficult oil
suction
清洗滤油网及管路，根据使用环境定期检查，
及时清洗更换
Clean the filter net and the
pipeline; perform a regular check according
to the usage environment; and implement a
timely cleaning and replacement
管路有死角
Dead angle
in pipeline
固定油管，防止死角产生
Fix the oil pipe to
prevent the occurrence of a dead angle
现象
Phenomenon
原因
Phenomenon
排除方法
Solution
压力不
稳
Greater
noises and
unst
able
吸油管漏气
Gas leakage from oil
sucking pipe
更换吸油管或拧紧管夹
Replace the oil sucking pipe or tighten the
pipe clip
Summary of Contents for YC6A Series
