76-QD0460EN-01Y00-00
17
■
7
．
Pairing
The product can be possible to communicate the rundown data (tightening OK only) to the
receiver for pokayoke TW-
800R series (hereinafter called “receiver”) made by Herutu Electronics
Corporation.
To make the communication effective, the pairing (initial connecting setting) between the tool and
receiver, is necessary.
7.1. Pairing Procedure
After putting on the power switch of receiver, proceed the pairing with the following procedure.
For the operational details of the receiver, refer to the instruction manual issued by Herutu
Electronics Corporation, attached with the receiver.
①
Install the battery pack to the tool.
②
Activate the tool by pulling the throttle lever once.
Be careful, since the main shaft of the tool rotates at the same time when the throttle lever is
pulled.
③
By pressing the light switch for pairing, at the same time put on the power switch.
（
Refer to the below
）
・
It turns to be in the pairing mode for 10 seconds
and the light switch for pairing is blinking.
・
After a lapse of 10 seconds from the pairing
mode, the pairing mode automatically finishes
and the light switch for pairing stops blinking to
put out the light.
If the pairing is not successfully done during
that period, put off the power switch of the
receiver again and re-start the pairing
operation
④
While the light switch for pairing of the receiver is blinking, do the pairing by pressing the push
button located on the backward of the tool with the flat bottom of TF pin 2x90. (Refer to the below.)
・
At the same time when it is pressed, white LED
on the back of the tool lights. Hold pressing
until the buzzer beeps.
・
At the same time when the long beep starts,
the white LED goes off and then, remove the
TF pin from the push button.
“
Light switch
for pairing
Power Switch
TF Pin 2x90
