YPP6830 Pulse Input Rate/Totalizer
Instruction Manual
70
The multi-point linearization feature (
nopts
) can be used to linearize the display for
non-linear signals. For instructions on how to utilize this feature, see Multi-Point
Linearization (
For instructions on how to program numeric values see
1.
Press the
Up
arrow button to scroll to the
Calibration
menu (
CAL
) and press
Enter
.
2.
The meter displays
nopts
. For a linear signal, press
Up
arrow. For a non-
linear signal, refer to Multi-Point Linearization (
3.
The meter displays
CAL
UNITS
. Press
Enter
to select the input units/pulse.
The menu will read
FuNiT
.
4.
Use the
Up
arrow to select the time unit. If entering display values in
units/second, press
Enter.
Otherwise, select the time unit. Refer to Pulse
Input Time Unit (
Time
UNIT
) on page 71.
5.
The meter displays
inp 1
. Apply a known signal and press
Enter
. The
display will flash while accepting the signal.
6.
After the signal is accepted, the meter displays
dsp 1
Press
Enter
. Enter a
corresponding display value for the signal input, and press
Enter
to accept.
7.
The meter displays
inp 2
. Apply a known signal and press
Enter
. The
display will flash while accepting the signal.
8.
After the signal is accepted, the meter displays
dsp 2
. Press
Enter
. Enter a
corresponding display value for the signal input and press
Enter
to accept.
9.
After completing calibration the
save?
display will need to be
acknowledged using the
Enter
key before calibration will take effect.
Important Programming Note: Save (
save?
)
After entering the last display value, the calibration entries must be saved (
SAUE?
)
before they will be put into effect.
However
, you may move past this selection
using the Up arrow key if you need to go back and correct and earlier entry. Once
confident in the entries however, the user must navigate back to the Save menu
screen (
SAUE?
) and press the Enter key to save the changes.