YPP6830 Pulse Input Rate/Totalizer
Instruction Manual
69
Calibrating the Meter (
CaL
)
To scale the meter without a signal source refer to Entering the K-Factor (
Factr
) on
page 38 or Scaling the Meter (
SCale
) on page 67.
The pulse input can be calibrated to display the process in engineering units by
applying the appropriate input signal and following the calibration procedure.
The use of a calibrated signal source is strongly recommended.
A calibrated input will work with Automatic Unit Conversions as described on page
45. The units for the display values that must be entered are a combination of the
programmed
Rate Unit
and the time unit (
Time
UNIT
) entered in the
Calibrate
menu.
For example, if the
Rate Unit
is gallons, and the time unit (
Time
UNIT
) is seconds,
the units for the display values entered in the
Calibrate
menu are gallons/second.