i
TI 33Q01J10-01E
Introduction
The CENTUM CS 3000 (abbreviated as CS 3000) is a distributed control system
(abbreviated as DCS) for small to large plants.
This manual describes the requirements for installation (control room size and power
supply requirements), storage and transportation, and wiring.
I/O modules which can be installed to AFS10S/AFS10D, AFS20S/AFS20D, AFG10S/
AFG10D, AFG20S/AFG20D, and PFCS/PFCD are called RIOs; I/O modules installable to
AFS30S/AFS30D, AFS40S/AFS40D, AFG30S/AFG30D, AFG40S/AFG40D, and AFF50S/
AFF50D are called FIOs.
Chapter 1 System Installation Requirements
This chapter describes engineering specifications covering control room design/environment,
power supply system, grounding and noise prevention. For power consumption specifications
and list of consumable parts, see Chapter 4.
Chapter 2 Transportation, Storage and Installation
This chapter describes precautions in transit, unpacking and storage, such as humidity,
temperature change, and how to install cabinets and 19-inch rack mountable devices.
Chapter 3 Cabling
This chapter describes how to connect power, ground, signal and bus cables to the installed
devices, and how to connect optical fiber cables.
Chapter 4 Installation Specifications
This chapter covers power consumption and power dissipation, in-rush current, fuse and breaker
ratings, and parts that need replacement within 10 years. Read this section when deciding power
supply capacity.
Chapter 5 Post-installation Inspection and Environmental Preservation
This chapter describes items that must be checked before applying power and the precautions to
be taken to safeguard the environment after installing the system.
All Rights Reserved Copyright © 1998, Yokogawa Electric Corporation
May 18, 2007-00