YG125-30A Maintenance Manual
Inspection and adjustment
37
cause serious hurt to skin and eyes by contact.
In case of contact with it, wash it off for 5
minutes and see a doctor immediately.
Brake lamp adjustment
If the rear breaks lamps abnormally light up and go
out, adjust it by turning the adjusting nut. If the rear
brake lamp switch is broken, replace it immediately.
Pull down the right side cover
Pull out and pull off the patch plug of the rear brake
lamp switch, and carefully pull out the rear brake
lamp switch wire and remove the rear brake spring.
Replace with new rear brake lamp switch and mount
it in the reverse order.
、
While installing, the wiring of the rear brake lamp shall be
in strict accordance with the wiring diagram, and replace
the buckle strip
While installing, the rear brake spring shall be reliably
hooked with the pin hole on the rear brake lamp switch.
After replacement, adjustment shall still be carried out to
the rear brake lamp switch.
Replacement of Fuse
Set the ignition switch to
“
OFF
”
position. The specified
fuse tube of 15A/10A should be used for main fuse
replacement, and a 10A fuse tube for FAI injection nozzle.
Open the left side cover, remove the fuse holder on the
side of the battery and replace the fuse tube.
If the new fuse tube is broken again as soon as it is
fitted on, it means that somewhere of the electric parts is
shorted unexpectedly.
Caution
Do not use any fuse over 15A/10A
Be sure not to wash the battery when washing the
vehicle.
Headlamp dimming
Before driving, check the brightness, direction, etc. of the
headlamp.
The adjustment can be made to the headlamp in the left /
right and vertical directions.
Adjusting nut
Rear brake switch
Fuse
Adjusting bolt
https://www.motomanuals.net/
